More > JRiver Media Center 22 for Windows

I am back (hopefully temporarily) to decoding by pre/pro [Solved!]

<< < (3/4) > >>

mattkhan:
that's the one

To debug, simply use the test tones in jriver (in tools/advanced/audio calibration iirc), play a single channel at a time and note which speakers play. Post the results.

If it's a question of your prepro getting things wrong then you could try the 5.1 in a 7.1 container format.

michael123:
I will try, although it worked fine before

Will do the mic test, in both 5.1 and 7.1


Thanks!

michael123:
5.1 and 7.1 make no difference

Left track sounds on Right
Right -> Center
Surround Right -> Left
Surround Left -> Surround Right

Complete mess!

Also, same in Windows Control Panel

I will check the cables on the weekend :-(

blgentry:
I remember reading something about the channel ordering being different with some interfaces.  Could michael's HDMI interface have different channel ordering?  Would that be something set in Windows, or something he'd need to change in MC's DSP Studio.

On the other hand, if MPC plays, using this same HDMI interface, with correct channel ordering, then maybe what Hendrik said... Could the pre-pro be mapping channels differently when it gets a PCM signal?  Maybe doing some kind of hokey psuedo surround, not realizing it's "real" multi-channel content?

Lots of questions and theories.  Sorry I don't have any concrete answers.

Brian.

michael123:
(1) I checked now the level calibration in the processor
(2) and checked the physical connections of the cables on the rear

Everything works fine. I hear pink noise from the corresponding speaker when using pre/pro setup


Help!!! :-(

Navigation

[0] Message Index

[#] Next page

[*] Previous page