More > JRiver Media Center 23 for Linux
Quick Start Guide for Installing JRiver Mediacenter 23 ARM on a Raspberry Pi
akira54:
--- Quote from: mwillems on July 23, 2017, 08:33:46 am ---Running Without a Monitor:
--- Code: ---x11vnc -storepasswd your_password ~/.vnc/passwd
--- End code ---
--- End quote ---
I tried the above command with "your-password" changed and received an error message: "bash: x11vnc: command not found"
tyler69:
Is there a timeline for video and/or tv support? If so, could you please share this information?
bob:
--- Quote from: tyler69 on September 07, 2017, 06:17:54 am ---Is there a timeline for video and/or tv support? If so, could you please share this information?
--- End quote ---
No timeline for TV support.
As for video, it is being considered.
mwillems:
--- Quote from: akira54 on September 07, 2017, 03:48:40 am ---I tried the above command with "your-password" changed and received an error message: "bash: x11vnc: command not found"
--- End quote ---
Apologies, I forgot to bring something over from the old method. First run "sudo apt-get install x11vnc"
akira54:
--- Quote from: mwillems on September 07, 2017, 05:53:32 pm ---Apologies, I forgot to bring something over from the old method. First run "sudo apt-get install x11vnc"
--- End quote ---
Thank you. Could you explain why this method of starting a x11vnc service is preferred over the built-in one which just enables VNC in the RPi's settings (together with ssh)?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version