More > JRiver Media Center 24 for Windows
NEW: ZoneSync 2
JimH:
The Pi may not have that capability yet. Is it an Id or just Linux? What version of MC?
Llannis:
Hi again,
so I played more with Zone Sync. Of course its functionality has improved a lot since the previous version. I still can't figure out the following,
Volume problem situations:
I go back and forward to Internal/Application/System Volume to understand which I should use at each one of my linked zones. Sometimes when I switch from one zone to another the speaker auto-mutes. When I go to the previous/next, the speaker starts again (it isn't though a specific Volume mode - it seems rather random).
Additionally as I mentioned before can I set one at 85% and the other at 100% and then volume up/down both (simultaneously) based on those settings?
Out of Sync situations :
I played a bit more with the Zone Sync. It seems that, when in playlist, the second (most of the times) or the third song always starts out of sync. If I press stop and then play, everything is synced. If I press to go to the next song, it gets more out of sync. Also, when I press to go to a point towards the end of the playing bar, it also gets out of sync.
verden:
--- Quote from: JimH on April 15, 2018, 03:51:15 pm ---It should work on Linux, but the build matters. Changes have been made in recent Windows builds, so the latest build of MC for Linux would be needed.
--- End quote ---
The Linux Builds are 24.0.15, the same as windows and mac builds. If Linux support isn't there yet,I don't think it explains windows not linking with mac.
ST:
JohnT, have you tested the MC24 timing with direct sound mode? Only some of my DACs can do WASAPI. I use direct sound for all except one DAC with ASIo.
JimH:
It may not work with DirectSound. WASAPI is recommended.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version