More > JRiver Media Center 24 for Linux
Quick Start Guide for Installing JRiver Mediacenter 24 ARM on a Raspberry Pi
badger:
FWIW if I play a track with VLC media on the Pi I do get audio through the HDMI, so at least I know the HW is hooked up correctly.
badger:
OK. My bad... I am getting HDMI audio but the volume was so low I couldn't originally detect it. My speakers are outside for this setup. Any suggestions on volume setup? Should I set the pi to 100%.. or is the MC volume related to the Pi setting?
mwillems:
--- Quote from: badger on March 08, 2019, 02:35:25 pm ---OK. My bad... I am getting HDMI audio but the volume was so low I couldn't originally detect it. My speakers are outside for this setup. Any suggestions on volume setup? Should I set the pi to 100%.. or is the MC volume related to the Pi setting?
--- End quote ---
I would just gradually adjust JRiver's volume to 100% first. If 100% is still too quiet, then gradually turn up the Pi's volume too. They may be linked or not depending on your volume settings in JRiver.
badger:
Thanks. I believe i'm all set. The way it is set up now the Pi volume seems independent so I just set it to 100% and then the volume adjustment in MC is all I need. JRemote and Panel volume works this way also when playing or rendering to the Pi so all is good!
JimH:
If you click on the speaker icon in the upper left corner of MC, there are three audio choices. I'm not certain that they work on the Pi, but it's worth trying.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version