More > JRiver Media Center 25 for Linux

JRiver 25 "Illegal Instruction"

(1/4) > >>

designmule:
Hi everyone

I recently updated my pi's to JRiver 25 and everything went fine. When I updated my Allo Sparky JRiver starts to open and then crashes. Starting it via command line produces the same result but returns the message "Illegal Instruction". I then uninstalled JRiver 25 and reinstalled JRiver 24. It runs fine and surprisingly retained all of my setting from before. I uninstalled it following the guides here on Interact. So I don't know if that might be causing an issue.

Any suggestions?

Thanks for the help
Matt

Hendrik:
Thats an ARM system, right?
I haven't heard of any changes in that area how we build stuff.

Anything particular you are doing when it crashes? Or simply running it, doing nothing at all otherwise?

designmule:
It is an arm system. ARM Cortex A9 Quad Core Processor at 1.1GHz.

I only use the device for music playback so other than the VNC service nothing is running and I am only attempting to start JRiver. I''m running DietPi (which I use on the pi's as well). I noticed that the version of JRiver was 25.0.50

My googling led me to think that it might be processor related as well. The DietPi installation page indicates that GPU features are not enabled if that matters.

bob:

--- Quote from: designmule on July 31, 2019, 04:00:51 pm ---It is an arm system. ARM Cortex A9 Quad Core Processor at 1.1GHz.

I only use the device for music playback so other than the VNC service nothing is running and I am only attempting to start JRiver. I''m running DietPi (which I use on the pi's as well). I noticed that the version of JRiver was 25.0.50

My googling led me to think that it might be processor related as well. The DietPi installation page indicates that GPU features are not enabled if that matters.

--- End quote ---
I don't think that should matter but you can try running it under gdb and upon the crash you might get more info. The symbols aren't there but it will probably give a general stack trace.

gdb mediacenter25
run
when it dies
bt full

thanks.

designmule:
So from terminal I first entered gdb mediacenter25 and it returned gdb license info, etc. then returned "Reading symbols from mediacenter25...(no debugging symbols found)...done.

The with gdb still open in the terminal I attempted to start medicenter 25 which crashed as it has been.

I then typed bt full in the terminal and gdb returned No stack.

I've never used gdb before so I've laid out my actions just in case I made a mistake.

Thanks for the help
Matt

Navigation

[0] Message Index

[#] Next page