More > JRiver Media Center 26 for Linux
Docker MC26 won't play to CXN
Robad:
Thanks for the response Scobie. I decided I had to start again so I've removed everything container-station-related. Trouble is, when I try creating new ones it fails! I can make some progress by un/re-installing Container Station. But I can't even get where I was before!
If you could tell me the necessary steps in simple terms, I'd be extremely grateful...
I'm currently at the "freshly installed Container Station" stage.
Rob
Robad:
I had another go. I created an "Image" from 'shiomax/jriver26". But it didn't allow me to specify anything. Now I can change some things - like NAT to Bridge - but I can't add a MAC address. How would I go about that?
Scobie:
You can only add those details on creation - through container station anyway. There are docker commands that allow you to do that via the docker command shell post creation, but that requires you to terminal into the NAS and find your way around. Much easier to do it on image create.
Robad:
I seem to have got it to work properly now...
For anyone else following in my footsteps:
- I had to create a container with Network mode set to "NAT". This allows you to enter a MAC address.
(Previously I created an "Application" - prefix "APP" - which allows you to use docker-compose. But it didn't work.)
- I also used DHCP. There seem to be conflicting opinions as to which is best. If you go for "static" you can't use the QNAP's IP address!
- After the container creation had completed, I changed the Network mode to "Bridge".
- So far so good...
I read somewhere on this forum that you should use 'HUP' instead of 'TERM' when killing the process. I have no idea how to do this. The console output shows that the QNAP container is using 'TERM'. However, I haven't upgraded my MC23 Master license yet, so I wouldn't know whether restarting the QNAP removes the authentication...
Rob
Robad:
Hi, I have got the trial version of MC26.0.87 running in Container Station on a QNAP NAS.
Two things I don't know how to do now:
- How do I install the license once I've purchased it?
- How do I upgrade? (My Windows version kindly told me an update was available. Not so with the Linux version...)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version