More > JRiver Media Center 28 for Linux
Docker Image for MC28
Richard Martin:
I don't have any port mappings in my set up and it works fine. What do you have on the network tab? I have Network Name=host and Driver=host
joetiii:
--- Quote from: max096 on November 29, 2021, 03:42:45 pm ---Use 1901 or something instead of 1900 then, looks like you already have another service that use 1900. Might be synology itself. You can also try without that port for now.
--- End quote ---
Hey Max, that worked. I changed out to 1901 and I can get it running without any errors now. Though I can not access anything using the WebGUI. I just get my synology home page when I put in <IP address:5900>. I am running in bridge mode, (not sure why the system set it up this way, because I know host mode is is easier for newbies like me than bridge mode.) I am going to try and switch the NAS over to Host mode. Any other things for me to check?
joetiii:
--- Quote from: Richard Martin on November 29, 2021, 05:13:27 pm ---I don't have any port mappings in my set up and it works fine. What do you have on the network tab? I have Network Name=host and Driver=host
--- End quote ---
Richard,
Any thoughts on how to switch from Bridge Mode to Host mode?
joetiii:
Well I disabled the Firewall on Synology and used :5800 in webGui and I got MC to appear. Quick question... is it OK to keep Firewall disabled or should set up an exception for the 5800 port?
HaWi:
On the Synology firewall settings allow the IP range of your local network and disallow everything else. The "allow" rule needs to be above the disallow rule. That way you can access from your LAN but nobody can access from outside.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version