More > JRiver Media Center 28 for Linux
Quick Start Guide for Installing JRiver Mediacenter 28 on an rPi4 2-4-8GB
Wheaten:
Thanks for your feedback, appreciated!
Zachik:
Anyone managed to successfully install on Raspberry Pi OS 64-bit and PI2AES hat (with RPi 4)?
MC28 (latest version) installed just fine, but I get no audio at all :(
I am connected to my DAC through the AES/EBU output of the PI2AES, and confirmed the hardware and connections are OK (using a Volumio image on a 2nd microSD card).
Running raspi-config, there is only 1 device in the Audio menu, so I cannot really choose the wrong one there...
In MC28, I tried each and every Audio output option. None gets any sound.
Ideas anyone?
bob:
--- Quote from: Zachik on February 22, 2022, 06:13:14 pm ---Anyone managed to successfully install on Raspberry Pi OS 64-bit and PI2AES hat (with RPi 4)?
MC28 (latest version) installed just fine, but I get no audio at all :(
I am connected to my DAC through the AES/EBU output of the PI2AES, and confirmed the hardware and connections are OK (using a Volumio image on a 2nd microSD card).
Running raspi-config, there is only 1 device in the Audio menu, so I cannot really choose the wrong one there...
In MC28, I tried each and every Audio output option. None gets any sound.
Ideas anyone?
--- End quote ---
Run the alsamixer and make sure the device isn't muted or it's mixer set to 0.
Wheaten:
If Bob's option doen't give the desired result, check the dtoverlay used in Volumio (/boot/config.txt or /boot/userconfig.txt) vs the one used for JRiver (/boot/config.txt). If they differ take the dtoverlay= line used in the Volumio and use the same for JRiver and see if that will do the job.
Zachik:
--- Quote from: Wheaten on February 23, 2022, 10:25:23 am ---If Bob's option doen't give the desired result, check the dtoverlay used in Volumio (/boot/config.txt or /boot/userconfig.txt) vs the one used for JRiver (/boot/config.txt). If they differ take the dtoverlay= line used in the Volumio and use the same for JRiver and see if that will do the job.
--- End quote ---
Bob's suggestion did not work (master volume was on 100% already), but...
dtoverlay= line was different.
Changing it to the same as on my Volumio working image.... Viola! WORKS!!!! :)
Thank you so much.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version