More > JRiver Media Center 28 for Windows

Display Settings Automatic Change Mode Issue on Intel iGPU (very specific)

<< < (2/2)

jmone:
So a clean install did not make any difference.  Same behaviour. 

FYI - The other weird HDMI sound issue I was referring to was that when I turn on HDR on this box, the AVR reports that it is only receiving 2ch PCM (Left and Right) even though windows is set to 5.1 or 7.1 etc.  As soon as I turn off HDR then it reports the correct # of channels. 

jmone:
Fixed it!  This setup always required a fairly long "Wait after change (use if display changes slowly)" setting of 5 secs.  Turns out it was not quite enough with HDR On.  Upped it to 10 sec and now it all works.

Note: I also found and applied a HDMI BIOS update for this unit

landogid:
Hey,

I'm experiencing a similar issue. I have an intel NUC connected directly via HDMI to a panasonic TV, and through a HDMI to VGA adapter to a samsung monitor. When I have both monitors connected and set to either extended or dupcliated view, I get display on both, but if I try just the tv it doesn't display anything.
Any idea how to resolve this?

Thanks,
Gidon

Navigation

[0] Message Index

[*] Previous page