More > JRiver Media Center 29 for Windows
JRVR MC29 Testing [Pre-release / Old]
jmone:
[Edit by JimH -- This thread is from the early development of JRVR in MC29. It has been superseded by a new thread that began about the time MC29 was first released.]
jmone said:
I've done some initial testing (all HDR Passthrough on Windows 11):
- 3090 / 1660Ti: No issues with all the "best" settings on material up to UHD HDR 59.94
- NUC (iGPU): Now this is pretty amazing. :o This NUC can also play UHD HDR 59.94fps when "Allow HW decoder direct rendering on mismatched size" is checked, without dropping frames! ... but I get a thick blue line (and it turns green if windowed). With "Allow HW decoder direct rendering on mismatched size" unchecked then it can play up to UHD HDR 50fps (and there is no blue or green line), but UHD HDR 59.94fps will drop frames. I know that subtitles are still a work in progress but every sub displayed results in a heap of dropped frames and the VSYNC jumps all over the place (from say 25 to 125hz).
Hoping to get time to look at the tone mapping stuff on the PJ tonight.
jmone:
The transfer of DV to HDR10 seems to work well and appears not to be too costly (well on my 3090). I'm using this file from Dolby to test http://media.developer.dolby.com/DolbyVision_Atmos/mp4/P81_GlassBlowing2_3840x2160%4059.94fps_15200kbps_fmp4.mp4
One question, however is I can not seem to "see" the DV info on any of my BD Rips (all to a folder structure) either though Full Menu or Title Playback. Is DV Supported in either mode?
Thanks
Nathan
Hendrik:
--- Quote from: jmone on January 25, 2022, 11:52:37 pm --- ... but I get a thick blue line (and it turns green if windowed).
--- End quote ---
Are you using the bundled LAV Filters? Its supposed to color it black. And I've also never seen it that large, curious.
(Edit: I think I found the reason for the large border, but with LAV 0.76 its still supposed to be black)
jmone:
Bundled LAV as part of the fresh MC29 install (with MC28 uninstalled).... and yup, it is not subtle.
jmone:
Is there an "easy" way to see what version of LAV it is using?
Navigation
[0] Message Index
[#] Next page
Go to full version