Devices > JRiver Id -- Hardware by JRiver

Wireless Setup for an Id

(1/1)

BradATIMA:
Configuring the WiFi can be a bit easier in GUI mode. The selected encryption type can be a problem.

Most access points use WPA 1/2 passphrase (not hex). Try changing it.

Toward the bottom of the configuration screen, change 'WPA 1/2 (hex)' to 'WPA 1/2 (passphrase)'. Then, enter the network password below. Make sure to save, and try connecting again.

bob:
Also, you can use a smart phone to configure it.

Connect to the Id as a network on an iPhone or Android. It will show up as Id-xxxxxxx where the xxxx is your Id's Id.
On an iPhone the wireless configuration will then immediately popup.
On an Android you connect to the network then open a browser and it should just popup the configuration when you try to open any site.
If it doesn't do that you can open
http://192.168.254.254

JimH:
You may have to turn off the wired interface.  (On the Id)

bob:

--- Quote from: JimH on April 21, 2022, 03:29:01 pm ---You may have to turn off the wired interface.  (On the Id)

--- End quote ---
As long as it's not plugged into an ethernet cable the wireless configuration page will be triggered within a minute of booting.

Navigation

[0] Message Index