Devices > Video Cards, Monitors, Televisions, and Projectors
MadVR exlusive mode blackblinking and glitches and washed out color no brightnes
tkolsto:
here is my file: Alien.Covenant.2017.2160p.BluRay.REMUX.HEVC.DTS-HD.MA.TrueHD.7.1.Atmos-FGT
trippel buffer off and set NP to full range and also in madvr which I already have it on full range. If I set both to limited I get darker image if I remember correctly.
and You write "nd auto for the LG display. " I dont understand this one...auto for lg display?
and You are correct on that it is not the latest b1 model. production is 2021 week 1. so this could be it but I doubt it I dont think that the problem on my tv is normal at all that many have this problem, they would have complained I would think.
Yes I could film it. I think I have done this once before but I was not able to post it on the forum to big file even if only some seconds long. And also strangely I think when I filmed it it was not so visable on film from a phone. something is not presented correctly. but how can I share it? I have no problem sharing it.
yes I have the same modes/profiles...filmmaker mode or dark expert..those are the ones I use too. but I have not calibrated them like You have or do You mean the madvr calibration under device in advance setting. Update: in hdr I only have filmmaker mode and no bright or dark expert mode.
One more thing. I tried to tick off the 3 first options in artifact removal in the processing tab in madvr adv setting. I get a steady rendering at about 30 ms...is this ok? when I have vsync on the osd show a headroom of 41 ms. Then it is good right? This is on the 3050 so If this is more than ok...I would say 3050 is more than good, albeit I am going to buy a new card in the future and now TV too as I want your setup which sounds awasome...from your descripton..it is what I get with interpolation at 7.
JimH:
Assuming that you're still trying to get madVR to work as you wish, please try this thread on doom9:
https://forum.doom9.org/showthread.php?s=2be3318350df2ab391cde4013abca199&t=146228&page=3180
I've forgotten why you can't use JRVR, our renderer.
You have problems with the video display and they seem erratic (one time with no problems, next time with problems). My first guess on a problem like that is always hardware, including drivers, or something like antivirus that interferes with files as they are read.
But it could be interference from some other source. Power, network, neighbor's table saw, etc.
I would not expect trial and error with madVR settings to be very useful. There is a thread on configuring madVR somewhere on this board. You could try returning to default madVR settings, then following the instructions in that thread.
I'd prefer that you use the doom9 thread now since this is not really much about MC.
Thanks, eve, and everyone else who helped.
tkolsto:
delete
tkolsto:
Could at least eve respond the last posts and then end it. I dont know why I have to do it all over again at doom9 as madvr is a part of MC. I have the same problem all along I thougth is was ok because the movie I tried it on did not reveal my problem..thus forth and back...I tried it on alien movie again showing it was like before...stutter doing 5 pulldown. People that read this knows that it is nothing wrong with Your product and this is a rare case..
JimH:
You can still work on it and post questions here, but doom9 is the best support for madVR.
Have you read other madVR threads here?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version