More > JRiver Media Center 30 for Mac

JRiver Media Center 30.0.66 for Mac Silicon/Intel Universal build

<< < (3/6) > >>

MellowVelo:

--- Quote from: AGAWA on February 27, 2023, 09:00:52 am ---excuse me the obvious: have you ticked Output Format in DSP?

--- End quote ---

Thanks. Yes, I have ticked Output Format in DSP Settings.

MellowVelo:

--- Quote from: retiredteacherguy on February 27, 2023, 09:01:36 am ---Maybe Exclusive Control is off?

--- End quote ---

Thanks. How do I check this? I certainly have not changed this setting myself.

bob:

--- Quote from: MellowVelo on February 27, 2023, 09:06:23 am ---Thanks. How do I check this? I certainly have not changed this setting myself.

--- End quote ---
It under Audio->Device settings.

Note that if you don't disable that auto-configure option, when you change to a different output device in the same zone, say HDMI on a Mac M1 your sample rates will be forced to the only rate it can do which is 48k.
They will stay that way when you change to a different device.
It makes sense to create separate zones for each output device so you can customize settings for each (the settings are per-zone).

MellowVelo:

--- Quote from: bob on February 27, 2023, 09:42:15 am ---It under Audio->Device settings.

Note that if you don't disable that auto-configure option, when you change to a different output device in the same zone, say HDMI on a Mac M1 your sample rates will be forced to the only rate it can do which is 48k.
They will stay that way when you change to a different device.
It makes sense to create separate zones for each output device so you can customize settings for each (the settings are per-zone).

--- End quote ---

Thanks. I will look into Exclusive Control when I'm home tonight.

I only use one output device, so the current issue is not being caused by switching between output devices.

retiredteacherguy:

--- Quote from: MellowVelo on February 27, 2023, 09:47:25 am ---Thanks. I will look into Exclusive Control when I'm home tonight.

I only use one output device, so the current issue is not being caused by switching between output devices.

--- End quote ---

Are you also routing system output/alerts to this device or is it only used for MC?

Navigation

[0] Message Index

[#] Next page

[*] Previous page