More > JRiver Media Center 31 for Windows
Possible to use profiles to switch between projectors?
jmone:
Actually, JRVR might already work as is for you. Under "Output" do you have two different Screens Listed (I do for my two monitors, but they are both connected) as you can configure seperate General/HDR/Calibration Settings already this way? ...or do you just have one regardless of what PJ is connected?
Hoi:
My 4090 GPU has 1 HDMI and 3 DP ports, I use 3 displays. I have the HDMI port connected to my LG OLED and DP1 & DP2 (DP to HDMI cable) going to my preamp. The HDMI OUT1 on the preamp is connected to my JVC NX7, the HDMI OUT2 is connected to the JVC RS500. All of my different JRVR HDR settings are saved and are automatically loaded depending on which display is active.
I used to use a splitter and had to manually change the settings each time.
FenceMan:
--- Quote from: Hoi on July 13, 2023, 06:55:36 pm ---My 4090 GPU has 1 HDMI and 3 DP ports, I use 3 displays. I have the HDMI port connected to my LG OLED and DP1 & DP2 (DP to HDMI cable) going to my preamp. The HDMI OUT1 on the preamp is connected to my JVC NX7, the HDMI OUT2 is connected to the JVC RS500. All of my different JRVR HDR settings are saved and are automatically loaded depending on which display is active.
I used to use a splitter and had to manually change the settings each time.
--- End quote ---
So JRVR sees through your AVR to the projectors? Mine seems to only see the AVR.
I am thinking I can try going out to both projectors and AVR all at once (I have 4070 with 1 HDMI and 3 DP)? I will just have to try but how will it know which display to pick if it sees both the AVR and a projector?
Hoi:
JRVR sees my Marantz/JVC when I have it on and switch to the whatever display that I want to use from the Windows 10. I use my LG OLED as my pc monitor in another room so JRVR defaults to that output device whenever I'm not using the Marantz/JVC. I set a hotkey for each of the 3 displays to do the switching.
jmone:
The other idea I thought of, is have a custom col. Called (say) "Projector" and a simple MCWS script you can run from a button press that would set the value to "PJ1" or "PJ2" for all videos (or even just "Blank" for PJ1 and "PJ2" for PJ2. That way you can have JRVR Profiles being selected if "Projector = PJ2" else it stays in default.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version