More > JRiver Media Center 32 for Mac

Something went wrong with playback [Solved]

(1/2) > >>

graham.colbourne:
I would appreciate some help having checked all usual settings. I am unable to play any audio file. Tried different outputs and different file types - sound cards, internal speaker, external headphones. A log file is attached. Get the message below:
"Playback Problem
Something went wrong with playback.
Details:
Playback could not be started on the output 'Core Audio1
using the format '44.1 kHz 2ch'.
This output format may not be supported by your hardware.
You can use DSP Studio to change the output to a
compatible format.
Also, make sure that your system has a valid sound
playback device and that it is properly configured in
playback options."

bob:

--- Quote from: graham.colbourne on March 09, 2024, 01:53:21 pm ---I would appreciate some help having checked all usual settings. I am unable to play any audio file. Tried different outputs and different file types - sound cards, internal speaker, external headphones. A log file is attached. Get the message below:
"Playback Problem
Something went wrong with playback.
Details:
Playback could not be started on the output 'Core Audio1
using the format '44.1 kHz 2ch'.
This output format may not be supported by your hardware.
You can use DSP Studio to change the output to a
compatible format.
Also, make sure that your system has a valid sound
playback device and that it is properly configured in
playback options."

--- End quote ---
The log says you are trying to play 4 track audio (Quadraphonic) on a 2 channel device.
If it really is 4 track going into DSP studio for and change the channel output to 2 (stereo) under output format.

graham.colbourne:
Thank you for checking the log and informing me. However, I had already tried the dsp settings on "source number" and "stereo". I have never set to "4 input". I tried again and still the same fault.

bob:
Why do you have
Tool->Options->Audio->Device Settings->Channel Offset set to 4?

graham.colbourne:
I tried adjusting channel offset (0, 2, 4 etc) as suggested in the device settings window to see if the setting was problematic. However no change.

I use RME sound cards and been checking possibility of drivers malfunctioning with Sonoma 14.4. At present I am not getting the "problem with playback" window, just no sound output. Also no playback signal showing in RME Totalmix software

Navigation

[0] Message Index

[#] Next page