Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Amfibius]

I have done a search and looked at old topics, but that has not helped me. In particular, I found this. It seems as if that guy gave up and got rid of his RME and got a Lynx instead.

What I want to do: use REW to generate a sine wave sweep and send it through JRiver's convolver via ASIO mode. This will require that I set up loopback in RME Totalmix.

What I need to do in detail:

1. Check that RME Totalmix is multiclient capable. A bit of googling says yes.

2. Set 48kHz in REW, Totalmix, and JRiver. Done.

3. Check that my config file is correctly loaded into JRiver's convolver.
---> Result: yes, I can play back music and hear it on my speakers.

4. Check that loopback is working.
- In REW, set output to ADAT3 and input to ADAT3
- In Totalmix, click on the "loopback" button in Hardware Outputs, then slide up the volume in ADAT3 "Software Playback" and "Hardware Outputs".
- Back in REW, press on "check levels". I can see the output bar, and I can see the input bar. The input bar disappears if I disable loopback.
- Use REW to do a measurement using loopback from 1Hz to 24kHz. Result: I measure a perfectly flat line.
---> To me, this confirms that loopback is working in Totalmix, and it is correctly sending output to ADAT3.

5. Find out what output channel ADAT3/4 sends to. According to Totalmix's Matrix view, this is OUT 13/14.

6. Open ASIO Live in JRiver
- Tools-Options-Audio-Advanced: "Set the active zone for WDM/ASIO driver live playback" TICKED.
- Configure ASIO: correct device chosen, 48kHz, 2 channels, Channel offset 13 (I also tried every number from 0 to 20!!!)
- In REW: play pink noise
---> RESULT: I don't hear any pink noise. JRiver says "ASIO Opening..." and that's it. Nothing happens.

I am pretty confident that I have loopback working correctly, given that flicking the loopback switch on and off makes the input bar appear/disappear in REW. So I do not think this is an error in RME setup.

Given the opinion on the other thread from pschelbert and mattkhan about MC having issues with some multiclient ASIO software and JimH saying that a problem was found and will be fixed, I am wondering if it actually has been fixed. For the record, that thread was about MC 28. I am on MC 31.

[mattkhan]

which RME interface do you have?

if you only want to measure your system then you can use the offline sweep method instead as that takes loopback out of the equation (as, depending on the system, that can also lead to instability in the audio stream that isn't present for simple playback)

it's basically https://wiki.jriver.com/index.php/Verifying_DSP_Studio#Generate_a_Measurement_Sweep though the specific options in rew have changed a bit since I wrote that (i.e. the REW UI has changed quite a bit)