INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: USB devices coming and going  (Read 1019 times)

DarkPenguin

  • Citizen of the Universe
  • *****
  • Posts: 1921
USB devices coming and going
« on: March 09, 2013, 12:34:08 pm »
I've a usb dac.  It can come and go.  If I set a zone's output to that device and it goes away I revert to the default and I have to switch back to that device when I re-add it.  I would rather have an error that the selected device was not found than have it do that auto magically.  Is there a way to set that?

Logged

DarkPenguin

  • Citizen of the Universe
  • *****
  • Posts: 1921
Re: USB devices coming and going
« Reply #1 on: March 10, 2013, 12:34:18 pm »
Today it remembered that it was set to talk to my HRT.  It failed to play.  When I stopped playback, re-added the HRT and hit play it crashed.

I don't mind this behavior.  I didn't have to dig into the settings.

Logged

mbagge

  • Galactic Citizen
  • ****
  • Posts: 255
Re: USB devices coming and going
« Reply #2 on: March 10, 2013, 12:53:19 pm »
What if you setup two zones, one for the dac and one for when the dac is gone. Then when you connect the dac again the dac-zone should remember it.
Logged

DarkPenguin

  • Citizen of the Universe
  • *****
  • Posts: 1921
Re: USB devices coming and going
« Reply #3 on: March 10, 2013, 02:49:17 pm »
Quote from: mbagge on March 10, 2013, 12:53:19 pm
What if you setup two zones, one for the dac and one for when the dac is gone. Then when you connect the dac again the dac-zone should remember it.

That's what I did.
Logged
Pages: [1]   Go Up
« previous next »