More > JRiver Media Center 18 for Mac

No USB Connection Yet on 19

<< < (2/3) > >>

Rogerdn:
New albums added yesterday to my HD did not self import like they did on 18, did I miss a set up ? Bigger problem 19 seems corrupted, after working for a day now all I get when opening is the spinning beach ball, can only force close.  Also I see that yesterday's new albums show up in 18 library and play.   

bplexico:
Are you using MC18 or MC19, or both? You mention importing albums, was that under MC18 or MC19? I would assume the imported albums would only show up in the version of MC you imported them under, unless you then did a library backup and restore to the other version of MC.

Rogerdn:

--- Quote from: bplexico on October 16, 2013, 02:34:06 pm ---Are you using MC18 or MC19, or both? You mention importing albums, was that under MC18 or MC19? I would assume the imported albums would only show up in the version of MC you imported them under, unless you then did a library backup and restore to the other version of MC.


--- End quote ---

I am attempting to switch to 19 and have only gone back to 18 to be able to listen to music, in doing so I noted the the new album I just ripped and was not in 19 was in 18. When I installed 19 I was able to import everything, it's just since this initial load I cannot add a new rip.  BTW it also imported to iTunes /pure music. So the album plays in 18 and PM but is nowhere in the 19 library. Plus 19 continuously locks up after one day of use.

bplexico:
I see, so did you rip the new album in MC18?

If so it wouldn't show up in MC19 unless you either imported it again, or Back up your library in MC18 and restore it in MC19.

Or perhaps I am confused, in which case my apologies.

I have been using MC19 with nary a hitch, however I realize that is no comfort, and not as if you are doing anything wrong.

Rogerdn:

--- Quote from: bplexico on October 16, 2013, 07:39:13 pm ---I see, so did you rip the new album in MC18?

If so it wouldn't show up in MC19 unless you either imported it again, or Back up your library in MC18 and restore it in MC19.

Or perhaps I am confused, in which case my apologies.

I have been using MC19 with nary a hitch, however I realize that is no comfort, and not as if you are doing anything wrong.

--- End quote ---

I rip from a PC on my LAN with dbPoweramp to my working drive so, then import, no restore.  I'm no longer going to use 19 until a later version is available, 18 works for me. Thks for your help.

Navigation

[0] Message Index

[#] Next page

[*] Previous page