More > JRiver Media Center 20 for Linux
openSUSE 12.3+ Setup for JRiver MediaCenter
rdok:
Hi again,
What might or might not be relevant (I am by no means a linux specialist) but maybe it helps somehow:
As MC did not work yet, I installed Kodi and as I forgot that is was renamed I started with looking in Yast software manager for xbmc.
Especially the last installed an awful lot of small packages (>1000).
Your missing libraries might be somewhere in there....
Mike Noe:
--- Quote from: bob on April 13, 2015, 01:23:46 pm ---If you stick with the 32 bit build you don't need gnutls26 otherwise you will need to get it somehow.
--- End quote ---
yep, it's the only thing needed....I found some code, can't get it to compile yet....32bit continues to work fine and I got sidetracked with an old Hammer Dynamics Super12 project..... ;)
rinring:
I'm using latest OpenSuse Leap 42.1, and I cannot find the alien package.
Any help please?
--- Quote from: geier22 on November 11, 2013, 04:14:19 pm ---Installation of 19.73 MC as rpm with zypper ( openSUSE 13.1 RC2)
The advantage over the method by hand: Media Center can easily uninstall via Yast. Then convert the new version and install it as described below. All data and settings are preserved.
Unfortunately Yast breaks the installation because of the lack of libcurl.so.4 (CURL_OPENSSL_3).
I have searched the whole web for this file and found nothing. libcurl.so.4 is installed.
1 Install alien
2 Install rpm_build
--- Code: ---sudo zypper install alien
--- End code ---
--- End quote ---
Mike Noe:
Add this repository:
Leap Utils
zypper in alien
rinring:
It works as a charm!! :) :)
Thanks.
--- Quote from: Mike Noe on November 25, 2015, 02:02:20 pm ---Add this repository:
Leap Utils
zypper in alien
--- End quote ---
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version