INTERACT FORUM
More => Old Versions => Media Center 14 (Development Ended) => Topic started by: jroyale on April 09, 2010, 10:25:33 am
-
My other post has taken a little but of a left turn so I'm starting a new one.
I'm running win 7 64 bit and I'm having issues registering cyberlink filters in 64 bit but they register fine in 32 bit. The issue then is that I am playing mkv's and when I select cyberlink as the filter, it won't load it instead defaulting to the next filter. So I then ran a program to show me what filters were installed and cyberlink showed up under 32 bit but not 64 bit. So I assume then that jrmc is playing mkv's in 64 bit mode rather than 32 bit. My assaumption seems to work because cyberlink loads and plays dvd and m2t files just fine presumably because it is playing them in a 32 bit mode.
Two things 1) does this sound right 2) is there any way to tell jrmc to play certain files in a 64 bit or 32 bit mode?
Admittedly I could be completely off in my assumptions but my troubleshooting to date seems to prove this out.
-
As I said in your other thread, I do not think 32bit vs. 64 bit matters. Media Center is a 32 bit program. It should happily accept a 32 bit filter.
-
I didn't see a direct answer in the other post.
It should happily accept a 32 bit filter.
It shoud but it's not and that is the problem. Likely the answer will be it's a win 7 or driver issue which at some point only takes me so far. In this case I think my logic is sound but then again I may be wrong. Setting cyberlink's refusal to register in 64 bit when I'm playing mkv's only those filters that are registered in 32 bit will load. If they are absent in 64 bit they won't load.