INTERACT FORUM

More => Old Versions => JRiver Media Center 30 for Mac => Topic started by: dgcrane on December 01, 2022, 01:37:51 pm

Title: PEQ filter confusion
Post by: dgcrane on December 01, 2022, 01:37:51 pm

Hello, I have been trying to figure this out with minimal success at this point. The following settings are meant to be entered into my parametric eq, but I have only been able to enter the LS and HS settings, but dont have a filter option for peaking....
Can someone give me some guidance on how to set the "peaking" filter parameters and set the preamp settings for my new LCD2s :)

I would be greatly appreciative of any advice on how to do this.

Thanks from a newbie,
Darren

Parametric EQs info provided

***You can use filters 1-5 or 1-10. Apply preamp of -5.4 dB or -5.3 dB, respectively.
#    Type    Fc (Hz)    Q    Gain (dB)
1    LowShelf    105    0.7    2.6
2    Peaking    228    0.28    -2.4
3    Peaking    4498    1.4    8.4
4    Peaking    5493    2.62    -9.3
5    Peaking    9766    1.85    4.1
6    Peaking    382    1.86    0.6
7    Peaking    799    2.63    -1.8
8    Peaking    1194    3.53    1.5
9    Peaking    1974    4.12    1.3
10    HighShelf    10000    0.7    -4.1

Title: Re: PEQ filter confusion
Post by: mwillems on December 01, 2022, 02:29:10 pm

The peaking filter in JRiver's parametric EQ is called "Adjust a frequency (equalizer filter)"

For pre-amp you'll want to use the "adjust the volume" filter.

Title: Re: PEQ filter confusion
Post by: dgcrane on December 01, 2022, 02:42:27 pm

Quote from: mwillems on December 01, 2022, 02:29:10 pm

The peaking filter in JRiver's parametric EQ is called "Adjust a frequency (equalizer filter)"

For pre-amp you'll want to use the "adjust the volume" filter.

Thanks sooo much for the clarification !!!!

Regards
Darren