INTERACT FORUM

Devices => JRiver Id -- Hardware by JRiver => Topic started by: Bohemian on March 20, 2021, 12:11:39 pm

Title: mc and vnc problem
Post by: Bohemian on March 20, 2021, 12:11:39 pm

Hi
I can connect to my idpi jriver mc via vnc but the screen only shows a part of the JRiver mc start page.  I cannot find a way to move down the page nor to the right.
If I try to customise a view I can see the options and change them but cannot access an ‘apply’ or ‘ok’ button because it is not in view.
Then I am stuck and can only reboot the idpi and the process starts again - only part of the mc screen is visible.
How can I rectify this?
Should I go to default setting and start all over?
I can see all of the main menu screen.
Any advice appreciated,
Chris

Title: Re: mc and vnc problem
Post by: JimH on March 20, 2021, 03:07:32 pm

Try something other than VNC.

Or explore VNC settings.

Title: Re: mc and vnc problem
Post by: bob on March 22, 2021, 09:00:50 am

If you are in GUI mode on the IdPi boot, with a monitor connected, that will set the desktop size to 1920x1080.

Once booted, if you aren't going to use a monitor going forward switch the IdPi to text mode and it will create a virtual 1920x1080 desktop.