INTERACT FORUM

Devices => JRiver Id -- Hardware by JRiver => Topic started by: markgough on February 16, 2021, 08:20:36 pm

Title: New NUC Id - fails to boot
Post by: markgough on February 16, 2021, 08:20:36 pm

I've had this NUC Id for a month or two. It's worked OK until today when several failed attempts at start-up ended with an "A bootable device has not been detected" message.

This is the NUC information: Id 25.0.11  MC 26.0.107-2 Engen 1.0.69, NUC 300 7CJYH

I'd welcome any suggestions! Thanks, Mark

Title: Re: New NUC Id - fails to boot
Post by: JimH on February 16, 2021, 08:35:35 pm

Check the cables to make sure they are tight.  Power off first.

Title: Re: New NUC Id - fails to boot
Post by: markgough on February 17, 2021, 03:26:58 pm

Doh! Loose power cord - fixed. Thank you!

Title: Re: New NUC Id - fails to boot
Post by: JimH on February 17, 2021, 04:00:13 pm

Good you found the cause.