INTERACT FORUM
Devices => JRiver Id -- Hardware by JRiver => Topic started by: magicLX521.com on February 22, 2017, 10:32:19 am
-
After having installed Id in my playback system, I m about to start to like the device in the playback chain... except for some nasty gliches, that appear ,
no matter what sample rate is played from SSD. LAN connected.
The USB- device (an AFI-USB reclocker, followed by a DSP/DAC) is currently plugged to one of Id s front plugs.
ID recognizes the device on CARD1 as "J20" with the name "JLsounds Hi-Rez audio 2.0"
In "output devices" , there appear serveral "J20" choices.
Even choosing front=CARD J20 does not prevent playback glitches , especially audible when music is low...
Maybe a driver problem or did I choose a wrong setting?
Thanks
Frank
-
If you're playing from a USB drive, and it's a USB 3.0 drive, then it needs to be plugged into a USB 3.0 port.
What happens if you plug the DAC in directly?
-
HI Jim
The DSP/DAC alone seems not to work at front USB.
I get DSP/DAC playing on the upper rear USB, with "output device" set to iec958:CARD=DAC...,
no glitches.
Connecting the reclocker "J20" to the same rear output , "output device" set to iec958:CARD=J20...
brings an overall more pleasant sound, but the glitches are here again...
Best
Frank
-
The USB part of AFI reclocker draws ca 500mA from the connected USB port
But its allows to feed 5V DC/500mA externally.
That did the trick. The USBplug on the Id seemed to be unhappy delivering 500mA.
Best
Frank