INTERACT FORUM
More => Old Versions => JRiver Media Center 22 for Windows => Topic started by: BCZ on April 03, 2017, 09:50:59 am
-
So I'm trying to use JRiver as an active crossover using a Asus Xonar U7. So under DSP Studio I enabled "Output Format" and selected 32 channels. While I don't need 32 channels (I only need 8), I am using these channels because it is easier to remember the mapping of channels and some channels are used for processing then summed into one. So basically I'm using channel 9-20 for left speaker and channel 21-32 for the right speaker. Channels 9-20 will eventually be summed and assigned to Left/Right/Center/Subwoofer while channels 21-32 to be assigned to SL/SR/RL/RR.
Anyways, I went to Parametric Equalizer and copied the left channel to channel 9-20 and right channel to 21-32. Now at this point I tried to play something, and I got the error "Playback could not be started using the format: 44.1 kHz 16bit 32ch".
What can I do to fix this error?
Thanks
-
It sounds to me like your audio device does not accept 32 channels. Is it supposed to? Its an 8 channel DAC afterall.
-
It sounds to me like your audio device does not accept 32 channels. Is it supposed to? Its an 8 channel DAC afterall.
That's what I think the problem is. Is there any way for JRiver to either ignore all the extra channels (because they're just temporary channels where I do my processing, sort of like scrap paper), or to delete these channels after I'm done? Even though I'm outputting 8 channels, I need about 24 channels to do my processing on (each 4 band compressor needs 4 channels, which is then summed back into one channel, and I need that on 4 of the channels, so 8 + 4x4 = 24 channels).