INTERACT FORUM

Devices => Sound Cards, DAC's, Receivers, Speakers, and Headphones => Topic started by: stanzani on September 14, 2018, 03:47:37 am

Title: [RME ADI2-pro] ASIO Loopback not working any more
Post by: stanzani on September 14, 2018, 03:47:37 am
Hello
this is for RME ADI2 PRO users using the ASIO loopback with JRiver.
back from holiday I update both JRiver 24, ASIO4ALL, RME ADI2PRO USB ADC and DAC) Firmware and Driver

My setup is as following

- a server PC hosting JRiver is connect by USB to the RME ADI2-PRO

- The balanced output of my pre phono is connected to he analogue balanced input of the RME (ADC)

- the RME is in USB mode (get and put adigital audio on the USB)

- RME clock source internal  @96K (sepecified by the driver on the PC

JRiver

- DAC: driver audio RME Madiface

- ADC: ASIO4ALL IN, with24@96K sampling frequency (RME told me I can use the SAME ASIO Madiface also for input but it never worked)

- DSP Studio: resample all formats at 24@96K

The pre phono is working (the RME ADI2 PRO set in preamp mode happily works)

This setup is intended to process the vynil sound with Dirac DRC and declicker by getting the vynil sound at 24@96 from RME A/D, ASIO-loopbacking into JRiver, apply DSP Studio and then sending via USB to the RME DAC.

This was working fine until July 2018 timeframe

Back from holiday, I upadted all (bad idea?) and the File->Open Live->ASIO Loopback (set the ASIO4ALL @96KHz) is not getting audio from the RME ...

Did anybody experienced this? Any advice?

Thank so much to anybody who'll help
Title: Re: [RME ADI2-pro] ASIO Loopback not working any more
Post by: stanzani on September 17, 2018, 03:09:24 am
Posted the same question to RME user's forum (tho whom who cares)
https://www.forum.rme-audio.de/viewtopic.php?pid=134266#p134266
Title: Re: [RME ADI2-pro] ASIO Loopback not working any more
Post by: stanzani on October 08, 2018, 07:58:11 am
At least is worked, though I experience some difficulties for JRiver to lock to the ASIO Driver of the RME. What most often works is as following
- enable Live/ASIO Loopback (no sound most of the times)
- turn off the DAW
- turn on the DAW (sound is starting aftern an initial difficult tentative