INTERACT FORUM
More => Old Versions => JRiver Media Center 28 for Windows => Topic started by: whoareyou on January 05, 2022, 09:28:28 am
-
When setting convolution to auto switch, everything switches as expected except for 176.4 and 352.8 rates.
The convolution status never shows these files as current filter.
All other rates work as expected
I am configuring via audiolense cfg files.
Each of these filters load as expected if explicitly selected, but JRiver will not auto select them.
Any suggestions?
-
Try using MC's DSP Studio > Output Settings to resample those to something that your sound device supports.
-
These rates are supported by my DAC (Exasound E38), so doubtful this is issue.
Everything plays fine for the 352.8 and 176.4 rates when the config files are explicitly configured.
Is it possible the correct filter is loaded but JRiver status is not properly reflecting the selected filter?
I am asking because although the Status indicates the wrong filter, the SSE real-time Performance has slowed to a level that seems to indicate the proper filter is probably loaded.
I don't have time to further investigate at moment, but based on JRiver reported performance, that seems like it could be happening.
Thanks
-
Issue was that naming convention did not follow JRiver naming convention.
My files were named 1764.cfg and 3528.cfg and JRiver is expecting 176.cfg and 352.cfg.
So, a bit of inconsistency with the other sample rates of 44.1 and 88.2, which are expected to be 441.cfg and 882.cfg
Would be very nice if the regular expression could be changed to accept file name with or without the decimal portion of sample rate.
Thanks