INTERACT FORUM

More => Old Versions => JRiver Media Center 31 for Windows => Topic started by: theriverlethe on May 19, 2023, 08:37:47 pm

Title: JRVR Frame Rate Switching Problem
Post by: theriverlethe on May 19, 2023, 08:37:47 pm

When I enable "automatic change mode" for frame rate switching with JRVR, videos turn into a slide show. The debug overlay suggests it's attempting to render at over 500 frames per second. Bringing up the GUI returns frame rate to normal, but as soon as the GUI disappears video is broken again. I'm using a 6800XT with latest drivers connected to an LG C2.

Title: Re: JRVR Frame Rate Switching Broken
Post by: jmone on May 19, 2023, 11:03:29 pm

Not that it helps but it is fine on my nvidia and intel setups.... You could try using "Custom" and specifying the res/hz for each of the options and see it that helps?

Title: Re: JRVR Frame Rate Switching Broken
Post by: jmone on May 19, 2023, 11:06:27 pm

Oh - and the other thing that may help is use "Wait after change..." in case it's an issue with playback starting before the HDMI re-sync is done.  Start with an absurdly large # like 10sec to see if it helps.  If it does, then drop it down till you get issues again then bump it back up. 

Title: Re: JRVR Frame Rate Switching Problem
Post by: theriverlethe on May 19, 2023, 11:27:54 pm

Thank you, but neither of those suggestions helped.

Title: Re: JRVR Frame Rate Switching Problem
Post by: jmone on May 20, 2023, 01:53:55 am

Worth a shot.  Hopefully someone with an amd card can chip in. 

Title: Re: JRVR Frame Rate Switching Problem
Post by: theriverlethe on May 20, 2023, 10:27:28 am

I had "Radeon Enhanced Sync" enabled and turning it off seemed to solve the problem.

Title: Re: JRVR Frame Rate Switching Problem
Post by: jmone on May 20, 2023, 04:08:43 pm

Nice Find!