INTERACT FORUM
Windows => JRiver Media Center 33 for Windows => Topic started by: mattkhan on September 21, 2024, 08:34:20 am
-
usually I just tell MC to resample to 48kHz so as to avoid needing to disturb audio device (which, in the past, has resulted in some pops so I just got used to leaving it to resample)
during recent testing I stopped resampling and notice that MC cannot drive the audio device to change reliably *and* start playback in one operation
i.e.
audio device is at some sample rate
press play for something that is at a diff sample rate
audio device changes to the target sample rate + MC reports "playback cannot be started"
press play again, playback starts normally
this feels like a timing issue, e.g. MC doesn't retry and/or wait long enough for the sample rate to change
is there any setting in MC to influence this?
it's an ASIO output device if it matters