INTERACT FORUM
More => Old Versions => Media Center 11 (Development Ended) => Topic started by: LisaRCT on November 12, 2003, 06:26:35 am
-
What are the possible causes for a library restore to fail?
I have had this error several times and wish to insure I do not see it again.
Are there any "Do's & Don'ts"?
-
One cause is a power failure at the PC. I made theese experiences... >:(
Uwe
@Lisa:
What's about your problem with the server connection ?
-
One cause is a power failure at the PC. I made theese experiences... >:(
Uwe
@Lisa:
What's about your problem with the server connection ?
I haven't had a power failure, but have had libraries fail to restore.
As far as the Media Server I have not been able to get that to work :-\
so I am running from a mapped drive.
One factor could be my weird network configuration . . . my internet (DSL) runs on TCP/IP protocol, but my network connections are made over IPX protocol (parallel protocol layers running on the same NIC / network cable, network hub).
I can't help but wonder if Media Server is looking to connect with a TCP/IP protocol and getting thrown off by the IPX being there instead ?
-
IPX and TCP/IP can co-exist on the same network. If the TCP/IP works, Media Server will work.
-
The TCP is only operating my internet conection (DSL modem to Hub then split to each PC)
The network is only connected on IPX