INTERACT FORUM

More => Old Versions => JRiver Media Center 18 for Windows => Topic started by: DarkPenguin on March 09, 2013, 12:34:08 pm

Title: USB devices coming and going
Post by: DarkPenguin on March 09, 2013, 12:34:08 pm

I've a usb dac.  It can come and go.  If I set a zone's output to that device and it goes away I revert to the default and I have to switch back to that device when I re-add it.  I would rather have an error that the selected device was not found than have it do that auto magically.  Is there a way to set that?

Title: Re: USB devices coming and going
Post by: DarkPenguin on March 10, 2013, 12:34:18 pm

Today it remembered that it was set to talk to my HRT.  It failed to play.  When I stopped playback, re-added the HRT and hit play it crashed.

I don't mind this behavior.  I didn't have to dig into the settings.

Title: Re: USB devices coming and going
Post by: mbagge on March 10, 2013, 12:53:19 pm

What if you setup two zones, one for the dac and one for when the dac is gone. Then when you connect the dac again the dac-zone should remember it.

Title: Re: USB devices coming and going
Post by: DarkPenguin on March 10, 2013, 02:49:17 pm

Quote from: mbagge on March 10, 2013, 12:53:19 pm

What if you setup two zones, one for the dac and one for when the dac is gone. Then when you connect the dac again the dac-zone should remember it.

That's what I did.