INTERACT FORUM
More => Old Versions => JRiver Media Center 19 for Windows => Topic started by: parisphoto on November 13, 2013, 02:59:11 pm
-
My Mytek has been out of my system for about a month.
Just hooked it back up and suddenly have two problems.
# 1 - I cannot play a native 16/41 file.
Windows / Control Panel / Sound / USB PAL Properties are only 24/41000, 24/48000, 24/96000, and 24/4192,000
# 2 - If I select ASIO as the Audio Output Mode in JRiver, all of the Output Mode Settings are blank.
Device Manager shows the Mytek, (Stereo 192-DSD Dac Device) under two headings; Sound Video And Game Controllers and Unknown.
No problems are shown in Device Manager.
If I delete the Unknown listing, it automatically deletes the listing under Sound And Audio Devices.
Is it possible that I have stopped a Windows Service?
If so, any idea which service might be the culprit?
I do not have another Dac to try.
These problems did not previously exist. Windows was not updated since last used the Mytek.
I have uninstalled and reinstalled my USB driver.
There should be no reason to upgrade the USB driver or Mytek Firmware, as it worked fine before.
Current Driver - 1.33.10.0
Current Firmware - 69 1.7.2
-
The WDM driver is 24-bit only. This is normal and good.
More here:
http://wiki.jriver.com/index.php/Audio_Bitdepth
-
Thanks Matt,
I know that this is not a JRriver or hardware problem, but I don't understand why both ASIO and 16 Bit are no longer options, as they were both accessible before.
My feeling is that it's a Windows setting.
Would you have any idea what Service I may have disabled that would cause this?