I am using 19.0.131. I have been using multiple set top boxes since it was first released a few weeks ago. I have noticed some strange behavior, but I haven't had the time to do much troubleshooting. It happened again today and I think I can describe what happened.
I have two Colossus capture cards each connected to a directv box.
Today at 5:00PM eastern I had a scheduled recording for a kid's show on Disney.
Today at about 5:15 PM, my wife tried to watch Food Network on the server (the box doing the recording) but the disney channel was displayed instead.
Then she tried to change the channel to HGTV and received an error regarding the tuner (she can't remember the exact error)
Then she tried to change the channel to DIY channel and received the same error.
At this point, she just turned the tv off
Tonight, we tried to watch the kid's program with the kids and it showed the first 15 minutes or so, then the recording changed to HGTV. After a few minutes, the recording changed to DIY channel.
It appears that the channel commands were being sent to the wrong box. I have seen similar behavior before, but I wasn't able to capture the steps.
If I use only one tuner at a time, everything works fine. I can confirm this by change the order in the tv setup or by not 'stacking' channels and tuning to the channels individually. That is how I know the ir blasters are mapped correctly.
I have a log file, unfortunately it is about 12 MB, so I can't email. I can put it out on google drive or something, if you would like to look at it.
Thanks,
Alex
