INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Assign Hauppaugue and Silicon Dust to different antennas  (Read 1289 times)

audiodoctor

  • Recent member
  • *
  • Posts: 21
Assign Hauppaugue and Silicon Dust to different antennas
« on: December 26, 2020, 07:46:46 pm »

I'm trying to assign 2 antennas to specific OTA channels in opposite directions- one towards Tucson, one to Phoenix. 
The 4 silicon dust tuners are assigned over the 4 Hauppaugue- hence, they don't fire up until the other 4 are busy.
Could this be addressed somehow in recording rules? if so I missed it. Thanks, Cornell
Logged

Yaobing

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 10926
  • Dogs of the world unite!
Re: Assign Hauppaugue and Silicon Dust to different antennas
« Reply #1 on: December 27, 2020, 01:42:49 pm »

You can assign preferred tuners to each channel.  Tucson channels should have different names and channel numbers from those Phoenix channels.  So if you record a show specifically from a particular channel, you should not have any issues after you assigned a preferred tuner to each channel.  If you choose to subscribe, and use "All channels", then there may be a problem.  You can try selecting as many specific channels as you want, instead of choosing "All channels", but order the selected channels.  MC picks a channel according to the order you picked when multiple channels air the same show at the same time.

Ordering channels during recording setup is a bit non-intuitive.  You need to open the drop-down, pick you first choice, close the drop-down, and then open it again to pick your second choice, etc.  - unless the channels are already ordered the way you want them, in which case you can pick them all at once.
Logged
Yaobing Deng, JRiver Media Center
Pages: [1]   Go Up