Devices > Sound Cards, DAC's, Receivers, Speakers, and Headphones
JRiver and Lynx aes16 ASIO behavior
(1/1)
adrixn:
Hello,
It's been a few years that I use this couple with pleasure but an aspect bothers me now.
It looks like JRiver uses a channel record for...what? And especially in my case it prohibits the use of the first two outputs (play 1/2).
In fact, the signal is visible on the meter but nothing is transmitted to the DAC.
For years I started using channel 3/4, but today I need to recover its two dead outputs.. I tried many things but without success.
Any ideas ..?
Thanks
eve:
--- Quote from: adrixn on March 29, 2023, 07:25:18 am ---Hello,
It's been a few years that I use this couple with pleasure but an aspect bothers me now.
It looks like JRiver uses a channel record for...what? And especially in my case it prohibits the use of the first two outputs (play 1/2).
In fact, the signal is visible on the meter but nothing is transmitted to the DAC.
For years I started using channel 3/4, but today I need to recover its two dead outputs.. I tried many things but without success.
Any ideas ..?
Thanks
--- End quote ---
Hmm, I've used a bunch of interfaces, not the Lynx. I've never seen JRiver try to take control of capture while doing normal playback to other audio interfaces that support recording.
I assume you've already tried fully resetting the Lynx mixer settings?
Beyond this, do 1&2 work in other software?
EDIT: now that I'm thinking about this more, have you tried using a different breakout cable? If the metering is showing that there's something getting 'to' 1&2, it makes me think cable or mixer routing config
adrixn:
Yes I even changed my computer since, and recently reinstalled some drivers, and yesterday I uninstalled/reinstalled the Lynx (which somewhat fixed another huge dropout problem in recording).
The behavior is the same from the beginning, despite the changes.
I will try to reconnect play 1/2 (but I ordered cables for that, I have nothing left).
In the meantime I checked, if I send the signal present on 1/2 to 3/4 (in the mixer), the signal is complete (unfiltered). While my configuration file for convolution does not use these two outputs..
I don't understand where the order to use them comes from.
EDIT: If I use REW in ASIO to generate a sine directly to 1/2 (redirected to 3/4) or to 3/4, I have the 1/2 record always on.
So it would rather be the Lynx and not a problem in JRiver...
(with REW in java I have huge dropouts)
kotani:
Just to add to this, my Lynx Two-B card does the same thing. When connecting with ASIO using jriver, I have the first two recording channels active due to jriver, just like your screen shot.
Navigation
[0] Message Index
Go to full version