Topic: Is there a list of Commands for mc11.exe ?? (Read 1776 times)

bbrip · « **on:** October 10, 2005, 03:49:01 pm »

Can I find attached list somewhere. Would be very useful for configuring Girder etc.

B

JimH · « **Reply #1 on:** October 10, 2005, 03:52:46 pm »

http://www.jrmediacenter.com/devzone.html

Is that what you're looking for?

bbrip · « **Reply #2 on:** October 10, 2005, 04:32:09 pm »

Yes but still refers to MC9. I thought there have been additions/changes to commands since then ??

B

datdude · « **Reply #3 on:** October 11, 2005, 12:20:29 am »

'requires Media Center 9.0.170 or later unless otherwise noted' - so i guess MC 11 counts as later.

marko · « **Reply #4 on:** October 11, 2005, 02:11:59 am »

Quote

Media Jukebox & Media Center
Command Line parameters
(last updated September 9, 2004)
(required Media Jukebox 8.0.317 or later)

Introduction

Media Jukebox can be controlled by command line parameters. Designing the Media Jukebox command line interface, we focused mainly on power and simplicity. Following these principals, we split the interface into two parts: (1) Execute parameters, and (2) Control parameters.

Execute Parameters

Executing one of the following parameters starts Media Jukebox / Media Center if it's not running.

NOTE: All Media Jukebox commands must be forwarded to MJExtMan.exe

also worth noting that anywhere you see mjextman.exe, if you're using MC11, replace that in your command line with MC11.exe

The windows messages listed here can be quite useful too.
-marko.

INTERACT FORUM

Author Topic: Is there a list of Commands for mc11.exe ?? (Read 1776 times)

bbrip

Is there a list of Commands for mc11.exe ??

JimH

Re: Is there a list of Commands for mc11.exe ??

bbrip

Re: Is there a list of Commands for mc11.exe ??

datdude

Re: Is there a list of Commands for mc11.exe ??

marko

Re: Is there a list of Commands for mc11.exe ??