INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: AV Sync MCC Commands Wiki  (Read 1471 times)

6233638

  • Regular Member
  • Citizen of the Universe
  • *****
  • Posts: 5353
AV Sync MCC Commands Wiki
« on: February 23, 2015, 10:02:45 pm »

Just noticed that the AV Sync command does not appear to be on the wiki page right now.

The command is: 28036, and any values specified are additive, rather than setting a specific value.
They also don't seem to support zone-specific commands. (sending MC20.exe /MCC 28036,100:6 ended up setting a ridiculously long delay rather than adding 100ms)
 
I'd add it to the Wiki myself, but it does not seem to be defined in the MCComands.h file so I'm not clear on how to find the specific command name to keep the information consistent.
Logged

Matt

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 41977
  • Shoes gone again!
Re: AV Sync MCC Commands Wiki
« Reply #1 on: February 27, 2015, 11:53:16 am »

Logged
Matt Ashland, JRiver Media Center

6233638

  • Regular Member
  • Citizen of the Universe
  • *****
  • Posts: 5353
Re: AV Sync MCC Commands Wiki
« Reply #2 on: February 27, 2015, 12:42:48 pm »

Excellent, thanks.
As I said, I'd have done it myself but did not know the specific command/parameter information.
Logged

glynor

  • MC Beta Team
  • Citizen of the Universe
  • *****
  • Posts: 19608
Re: AV Sync MCC Commands Wiki
« Reply #3 on: February 27, 2015, 01:40:18 pm »

MrC maintained that page.  And most of DevZone.

😰
Logged
"Some cultures are defined by their relationship to cheese."

Visit me on the Interweb Thingie: http://glynor.com/

6233638

  • Regular Member
  • Citizen of the Universe
  • *****
  • Posts: 5353
Re: AV Sync MCC Commands Wiki
« Reply #4 on: March 17, 2015, 07:53:11 am »

Rather than start a new topic on this, it would be nice if the MCC command was a little smarter.
 
When you use this command, any changes you make are applied to both 24Hz and the 50/60/120Hz corrections.
 
Since MC is aware of what is currently in use, it would be nice if the command only affected whichever is currently being used, rather than both. (the values for them are quite different here)
Logged
Pages: [1]   Go Up