ICE

Please login or register.

Login with username, password and session length
Advanced search  

News:

ICETCP.PRO and ICETCP.PLUS are compatible with Windows 11!

Author Topic: Cannot "Screen Print". Getting Cannot Create Printer Device.  (Read 1474 times)

DarrenD

  • Newbie
  • *
  • Posts: 1
Cannot "Screen Print". Getting Cannot Create Printer Device.
« on: April 25, 2007, 05:43:46 pm »
Needing assistance.  Have an Imagistix FX3000 printer on a TCP/IP port.  Prints fine from Windows and the Unix Application through DejaVu Plus, but will not Screen print.  The full error message reads:
Cannot create printer device.  Printer job was not accepted.  Please check printer setup.
« Last Edit: April 25, 2007, 05:45:27 pm by DarrenD »
Logged

Bob

  • Administrator
  • Ice Artist
  • *****
  • Posts: 1607
Re: Cannot "Screen Print". Getting Cannot Create Printer Device.
« Reply #1 on: April 26, 2007, 09:50:53 am »
The version number of plus would be helpful. It's in Help->About Dejawint

I'm going to assume that when you say:
Prints fine .. and the Unix Application through DejaVu Plus
you are probably mean with ICELP.

Given these assumptions, you probably need to change the local print setup in Plus. File->Local print setup.
Select your printer there, close Dejawint, re-run Dejawint  and see if that fixes it. If not, rerun local print setup and select the raster print checkbox, close Dejawint and re-run it trying the printscreen again.

Report results (and version number please).

Logged
 

Page created in 0.067 seconds with 17 queries.