Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[Heathwood99]

Hello,

I am having some success with this using the digital pre amp mode on the CA renderer.

I am able to decrease the volume using the slider on JRemote on my IPad, however when I try increasing the volume the slider pops back to a 28% value and no volume increase is heard.

My MC Center version is MC20 (I don't get on with 21).

Has anyone else had a similar experience to this?

 

[JonFo]

Also on MC20, my JRemote will not issue remote volume commands, the sliders moves and shows the setting I pick, but no changes on the renderer (an Onkyo TX-NR818).
My other issue is: at the start of each track, the volume is reset to zero.

[AndrewFG]

Also on MC20, my JRemote will not issue remote volume commands, the sliders moves and shows the setting I pick, but no changes on the renderer (an Onkyo TX-NR818).
My other issue is: at the start of each track, the volume is reset to zero.

The volume is set to zero. And you cannot change the volume. So you never hear anything. Right?

[Heathwood99]

Also on MC20, my JRemote will not issue remote volume commands, the sliders moves and shows the setting I pick, but no changes on the renderer (an Onkyo TX-NR818).
My other issue is: at the start of each track, the volume is reset to zero.

JonFo have you got a "digital preamp mode" setting on your Onkyo?

Unless I set this on my StreamMagic, the ability to control volume in JRemote will not work.