Hello
this is for RME ADI2 PRO users using the ASIO loopback with JRiver.
back from holiday I update both JRiver 24, ASIO4ALL, RME ADI2PRO USB ADC and DAC) Firmware and Driver
My setup is as following
- a server PC hosting JRiver is connect by USB to the RME ADI2-PRO
- The balanced output of my pre phono is connected to he analogue balanced input of the RME (ADC)
- the RME is in USB mode (get and put adigital audio on the USB)
- RME clock source internal @96K (sepecified by the driver on the PC
JRiver
- DAC: driver audio RME Madiface
- ADC: ASIO4ALL IN, with24@96K sampling frequency (RME told me I can use the SAME ASIO Madiface also for input but it never worked)
- DSP Studio: resample all formats at 24@96K
The pre phono is working (the RME ADI2 PRO set in preamp mode happily works)
This setup is intended to process the vynil sound with Dirac DRC and declicker by getting the vynil sound at 24@96 from RME A/D, ASIO-loopbacking into JRiver, apply DSP Studio and then sending via USB to the RME DAC.
This was working fine until July 2018 timeframe
Back from holiday, I upadted all (bad idea?) and the File->Open Live->ASIO Loopback (set the ASIO4ALL @96KHz) is not getting audio from the RME ...
Did anybody experienced this? Any advice?
Thank so much to anybody who'll help