Devices > Video Cards, Monitors, Televisions, and Projectors
Dropped frames after changing projectors
JimH:
--- Quote from: curiousMonkey on September 18, 2020, 09:06:53 am ---I don't know how to modify MadVR. All I did was choose Red October HQ and select the hardware assist check box in MC26.
--- End quote ---
Try unchecking it.
curiousMonkey:
Here is what I have tried so far:
1) Red October Standard - 3 years with Sony projector (no problems) then 1 week with new JVC projector (dropped frames).
2) Red October HQ with JVC (dropped frames)
3) Red October HQ + hardware assist with JVC (dropped frames)
tij:
Your rendering times are within a limit of your 24fps. Buy you have lots of dropped frame, which is strange (unless you been fast farwarding a lot before you took screen shot ... it takes a second after fast farwarding for movie to play smooth)
Dropped framed you may be perceiving might be be because you playing 29.97fps movie at 24fps
Movieman:
I'm guessing when you installed the new projector, the PC saw a new device and reset its video settings.
The movie shows a refresh rate of 29.97 which is standard for DVD even if the film is encoded at 23.976. Your video card refresh rate is set to 24 (which in itself is incorrect as Blurays are actually encoded at the 23.976 fps rate. First, set the video card refresh to 23 or 29 on your PC. Then let's see where we are.
Hendrik:
The DVD might actually be truely 29.97 fps, which would look rather bad when played on 24 Hz, as it would need to drop a lot of frames.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version