More > JRiver Media Center 27 for Windows
JRiver Media Center 27.0.85 for Windows -- Available Here
jkrichards:
--- Quote from: nickt1 on May 09, 2021, 04:31:35 am ---Hi There, I had been streaming radio Paradise successfully by adding the URL link:
https://stream.radioparadise.com/flac
Until I updated to the 27.0.85 version and it stopped working coming up with "nothing to play".
Ah -I hear you say why not just use the streaming link loaded in the task bar and on the JR streaming page?
This is also problematic as it has a gap in the playback towards the end of the track which gets old fast.
Any help in solving either of these issues would be appreciated.
Thank You
--- End quote ---
Yes... That annoying gap has never been fixed. A work around is to use large buffer. 2000ms or more. Then the issue is a slow response time.
KENJE:
I can't Burn CD's anymore on my JRiver 27. Even a Test mode won't work. It just goes to Writing In then just stays there. Dose not Burn at all.
I have now wasted 9 Blank CDR's.
nickt1:
--- Quote from: jkrichards on May 09, 2021, 10:05:01 am ---Yes... That annoying gap has never been fixed. A work around is to use large buffer. 2000ms or more. Then the issue is a slow response time.
--- End quote ---
Thanks for the reply JK, I tried increasing the buffer and it reduced the gap -its there every song to remind you that JRiver really dont care about their product and that Foobar works just fine...
CJBadge:
Trying to install MC27 in a new build. I download the installer and when I attempt to run the program I receive an "Extraction Failed" "File is Corrupt" error and the installation will not advance. Any advice? I've turned off all the Windows Security features temporarily, but that didn't work. I've tried several times to re-download the installer, but it's still not working. Thanks, CB
JimH:
--- Quote from: CJBadge on May 23, 2021, 09:30:34 am ---Trying to install MC27 in a new build. I download the installer and when I attempt to run the program I receive an "Extraction Failed" "File is Corrupt" error and the installation will not advance. Any advice? I've turned off all the Windows Security features temporarily, but that didn't work. I've tried several times to re-download the installer, but it's still not working. Thanks, CB
--- End quote ---
Try the 32 bit version of MC.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version