More > JRiver Media Center 29 for Mac

Static/noise/distortion on Chord Hugo TT 2

<< < (4/4)

bob:
Perhaps the device driver output is still open because you are pausing not stopping?
If that's the case, MC will not re-choose the output device sample rate (done only on open) it will just send more data to the device.

There is a feature in MC's options called "Stop after Long Pause" (search for that at the bottom search bar in options).
Turn it on and see if that solves your issue.

(note that starting in 29.0.30 the sample rate should be checked on un-pause so perhaps this is simply a state issue which also would be solved by Stop after Long Pause).

cantara256:

--- Quote from: blgentry on May 10, 2022, 01:41:22 pm ---Why are you turning your DAC off?  What would happen if you left it on all the time?  That seems like a fairly simple way to get around your issue.

--- End quote ---
I asked, and the manufacturer recommends NOT keeping the DAC on all the time.

cantara256:

--- Quote from: bob on May 10, 2022, 06:06:41 pm ---Perhaps the device driver output is still open because you are pausing not stopping?
If that's the case, MC will not re-choose the output device sample rate (done only on open) it will just send more data to the device.

There is a feature in MC's options called "Stop after Long Pause" (search for that at the bottom search bar in options).
Turn it on and see if that solves your issue.

(note that starting in 29.0.30 the sample rate should be checked on un-pause so perhaps this is simply a state issue which also would be solved by Stop after Long Pause).

--- End quote ---
That seems to have fixed the issue, thank you! Any idea how long a "Long Pause" is? A few seconds it seems? At least as long as it takes to power cycle the TT2 apparently...

Navigation

[0] Message Index

[*] Previous page