INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Can JRiver output mono below a specific frequency on a full-range speaker?  (Read 540 times)

jan.didden

  • Recent member
  • *
  • Posts: 24
Can JRiver output mono below a specific frequency on a full-range speaker?
« on: January 29, 2023, 08:11:35 am »
I have a pair of full range electrostats, QUAD ESL 989.
I would like to sum the L and R signals to mono below say 120Hz only, to limit the diaphragm excursion below that frequency and still have the right bass level.
Can I do that, for instance in the DSP function?

TIA

Jan Didden
Logged

jan.didden

  • Recent member
  • *
  • Posts: 24
Re: Can JRiver output mono below a specific frequency on a full-range speaker?
« Reply #1 on: February 01, 2023, 04:36:14 am »
Member Wesayso educated me: In the DSP, you can enable M-S encoding, which splits the signal in a mono component (M) and a stereo component (S).
Next, high-pass the S component only, which leaves the low frequencies in the M(ono) channel.
Then, enable M-S decoding which should restore the stereo signal, but now with the low frequencies mono-d below the high-pass freq mentioned above.

I'm not sure about the relative levels in this situation. Do they have to be adjusted before doing the decode step?

Jan Didden
Logged
Pages: [1]   Go Up
« previous next »