More > JRiver Media Center 31 for Windows
JRVR Video Renderer
mattkhan:
There are hardly any settings and no one knows what an individual system is doing so you probably just need to ask specific questions instead and/or just try it
Shinji Mikami:
At least they should explain the product they are selling.
JimH:
Please see the wiki.
Accept defaults if you need to. It's not complicated.
Macareno:
--- Quote from: Wull on August 16, 2023, 02:39:07 pm ---I second that. I would like to use JRVR-tone mapping for both an oled and projector, but keep going back to madVR because I'm not sure what settings to use.
--- End quote ---
Here in the same situation. I'm trying the trial version, but I can't find information to set up JRVR to get betters results with a JVC X7000 model. I would like to know what values to set in the tonemapping section.
Nicog:
I'm almost newby in JRVR and MadVR, but this is my configuration for HDR :
>use the display's HDR capability -> No
>Target Peak Nits -> 70 nits (what I read with my x-rite idpro)
>Target SDR contrast -> 10000:1
>Enable HDR to HDR tone mapping -> yes
>Reduce gamut to DCI-P3 -> yes (but for what JRVR is sending REC709 to projector)
>HD to HDR Target Peak Nits -> I don't understand what it is - I left it like that
>Enable contrast recovery -> I left 0.4 (I don't really see any change... Does it change gamma for darkest areas?)
My setup is a JVC X7900, fed by a PC with RTX 4070Ti, in a dedicated room (fullblack). Screen is a white microperforated - basis 2.6m
Further comments would be really appreciated :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version