More > JRiver Media Center 33 for Windows

Can't get MCC Command MCC_PLAY_PAUSE to only work for a specific Zone

<< < (4/4)

Matt:

--- Quote from: zybex on October 17, 2024, 02:18:31 pm ---Yes, but OP is saying that "mc33.exe /MCC 10000,0:0" is routing to the current zone instead of zone 0 as it should.

--- End quote ---

I was testing that exact thing and it was working nicely. So we need more details from the OP to get to the bottom of it.

datdude:
Sorry for the late reply. I just tested the 10000,0:0 syntax again and it is working now. I had a command saved in eventghost with that syntax so the only thing that changed was a reboot of windows at some point. It definitely was not working no matter what combination of numbers I tried for about an hour and then I gave up until I tried it again just now. Sorry for the troubles. Thanks for looking int it guys.

Navigation

[0] Message Index

[*] Previous page