INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: How to set SmartList Properties?  (Read 893 times)

bob_j

  • Regular Member
  • Recent member
  • *
  • Posts: 12
  • nothing more to say...
How to set SmartList Properties?
« on: December 15, 2002, 07:47:00 am »

I can't figure out how to set the properties of a smartlist.  The interface is not intuitive and the help doesn't help.  I can make a new smartlist but can't set the properties.  Can someone give me a hint?
Thanks
bj
Logged

bob_j

  • Regular Member
  • Recent member
  • *
  • Posts: 12
  • nothing more to say...
Re: How to set SmartList Properties?
« Reply #1 on: December 16, 2002, 01:22:48 am »

Does anyone know how to do this or is this a stupid question?
Logged

Phil Lee

  • Regular Member
  • World Citizen
  • ***
  • Posts: 241
Re: How to set SmartList Properties?
« Reply #2 on: December 18, 2002, 03:54:20 am »

At the top of the smartlist screen there is an entry field where you can enter smartlist parameters manually or click on the wand button on the left hand side to show a menu listing all the parameters to create your query.

You can see an example here:

http://www.home.earthlink.net/~ashawley01/data/smartlist_example.htm
Logged

bob_j

  • Regular Member
  • Recent member
  • *
  • Posts: 12
  • nothing more to say...
Re: How to set SmartList Properties?
« Reply #3 on: December 22, 2002, 01:38:19 am »

Phil,
Thanks so much for answering my question.  I would have never found that wizard button.  This helps me a lot but still doesn't completely answer my question.  

I have a lot of comments about the interface.  I'm going to start another thread because I don't think the developers will see this one since they didn't notice my original question.
Thanks again
bj
Logged
Pages: [1]   Go Up