Hi,
I decided to test the new convolution-engine (finally throwing myself into DRC). Well, I cannot get it to work - most likely because of my own lack of abilities.
Anyway, could someone assist me and try load the filters from the link below - or just take a look at them to see if they are in the correct format etc. It consists of a config-file and two filtres (stereo-setup). You will have to adjust the config-file depending on where you save the filters on your HDD.
The two filters were generated from REW-sweeps, then exported as 16 bit 44.1khz impulse response filters (mono).
I then enable the convolution engine, load the config-file, play a pink PN-signal and look at the analyzer. No reaction. Tried it on two different computers (using directsound).
http://www.mediafire.com/?33a31fxgs7ur4qiEDIT: I should perhaps mention I'm using build 68.
Best regards,
Mikkel