More > JRiver Media Center 20 for Linux
JRiver Media Center 20.0.131 for Debian (Jessie) AMD64
bob:
--- Quote from: Hendrik on April 28, 2015, 04:35:36 pm ---You would just remove the entire arch entry if you want the amd64 version (its only required to get one not matching your system), and switch the wheezy to jessie.
Note that it may not be in the apt repository yet, since it was the first build for jessie, bob prefers to be cautious and post it here first.
--- End quote ---
Correct, there isn't a jessie in the repository yet.
UdoS:
--- Quote from: bob on April 28, 2015, 11:58:41 am ---Tried as much as possible to get this to work. I think the version of gnutls28 you have is just too old. I get the same behavior on Ubuntu 14.04
If someone else has ideas on this I'd be interested in hearing them. gnutls is required for networking (it's what is used for secure connections).
This isn't an issue for the i386 build because it has gnutls statically linked in (not possible for amd64).
--- End quote ---
Hi
I'm running SUSE 13.2 and had the same problem. I downloaded the lib "libgnutls-deb0-28_3.2.16-1ubuntu2_amd64" from the internet and extract it into "/usr/lib64". Now MC is working again, but the main window behavior is very strange and slow.
As soon as I move the cursor into the window, display action is slowing down, but the playback continues flawless.
I'm using the Bose Soundlink as a second device. Now, the remote control via soundlink is working! 8)
UdoS:
Some more things about the remote control:
I checked back to the previous version x.95: no remote action. With this version (x.100), the remote control is possible, but the MC-window must be the active window. As soon as you make a different window the active one, the remote is not functioning any more, 'til you give the control back to the MC-window.
I don't know, whether remote was possible before at other installations. I'm running SUSE 13.2 and it was never working.
InflatableMouse:
Is this one expected to work on Arch x64?
I checked all the dependencies and I think they are all there, including gnutls26. When I run it I get a segmentation fault.
bob:
--- Quote from: InflatableMouse on May 01, 2015, 01:15:04 pm ---Is this one expected to work on Arch x64?
I checked all the dependencies and I think they are all there, including gnutls26. When I run it I get a segmentation fault.
--- End quote ---
No idea if it will run on Arch x64, I'd expect it would be easier to get running since it's based on Jessie.
You might want to check the forum post with the list of required libraries. It's been updated. We no longer use gnutls26. It's guntls28-deb0 or something like that.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version