INTERACT FORUM

Please login or register.

Login with username, password and session length
Advanced search  
Pages: [1]   Go Down

Author Topic: Setting up an AMOS/DTS:X Zone  (Read 2313 times)

rec head

  • Citizen of the Universe
  • *****
  • Posts: 1009
Setting up an AMOS/DTS:X Zone
« on: September 14, 2016, 06:01:09 pm »
I will be getting a new AVR soon and will have an ATMOS/DTS:X setup. I would like to setup a zone that will bitstream those movies while everything else doesn't bitstream. I have been using MC since v17 or 18 and did pretty much all my setting up then and haven't really had to make any changes to MC except maybe to get 3D working. Can someone please either point me in the right direction or give me some instructions? Consider me a beginner at this point.

Thanks
Logged

JimH

  • Administrator
  • Citizen of the Universe
  • *****
  • Posts: 72439
  • Where did I put my teeth?
Re: Setting up an AMOS/DTS:X Zone
« Reply #1 on: September 14, 2016, 06:28:49 pm »
On the wiki, please read about Zones and ZoneSwitch.  Make two zones and configure each the way you want.

The zone for atmos would be configured for bitstreaming.

Logged

rec head

  • Citizen of the Universe
  • *****
  • Posts: 1009
Re: Setting up an AMOS/DTS:X Zone
« Reply #2 on: September 15, 2016, 07:53:42 am »
Thanks. I'm suffering a sinus infection and not thinking too clearly. I should have checked the Wiki instead of just the forum. How do I mark the ATMOS titles to trigger the zone?
Logged
Pages: [1]   Go Up
« previous next »